Home > How To > Manual Pool Vacuum Not Working

Manual Pool Vacuum Not Working

Contents

Dave J. Swimming Pool Tips, Reviews & How To -MrDgvb1 273,555 views 5:02 Watch How a 6 Year Old Can Clean an Inground Swimming Pool!!....Can You? - Duration: 3:20. Make sure the hose is inserted into the suction hole at the bottom of the skimmer. If Kreepy Krauly slows or stops and air bubbles enter the pool at the return line.

I also tested the water, and it needs a lot more chlorine and acid. For a suction pool cleaner that is not working at all, the first step is to check the cleaner hose to make sure that it is firmly attached to the suction Even had a little diagram stamped on it that I didn't see that showed which end goes where..I felt like such a boob after cursing at it and reajusting my skimmer What should I do in the am? http://www.troublefreepool.com/threads/27608-Help!-Manual-vacuum-doesn-t-have-suction-Need-2-clean!

How To Vacuum Pool With A Hose

You can only upload photos smaller than 5 MB. Or switch to an anti-vortex cover If main drain is not flush with the pool floor, causing Kreepy to get stuck, use a drain cover such as the Polaris Unicover. But really, help is out there and by following just a few simple steps, you can actually troubleshoot your automatic pool cleaner and get it running again. The flapper is located inside the main body and must move freely at all times.

One goes to the bottom drain. If Kreepy Krauly gets stuck on obstructions such as safety ledge, ladders, steps, swim-outs Remove dive float restrictor and install a wall climb adjuster (Part # K12065), shown here. Ayesha Aslam InTheSwim Staff Blogger Posted in How To Pool Blog Posts Tagged automatic pool cleaners, pool cleaner troubleshooting permalink About Ayesha Web Content Specialist, Swimming Pool Enthusiast View all posts How To Vacuum An Inground Pool Pull out the grids and hose them off well.

I have a sand filter and multiport valve. I firstly suggest you check the diaphragm for blockage, damage or wear. I need help Matt Giovanisci This should help: http://www.swimuniversity.com/how-to-get-rid-of-mustard-yellow-algae-in-a-pool/ Debi Butler Friis I have worked my self crazy with the vacumn system.

I had to wait until I took it apart and measured the height of the screens to identify which model I had from the owner's manual.

Reply Idris Nomani on December 21, 2015 8:35 pm I recently purchased a Dominator. How To Hook Up Pool Vacuum To Intex Pump Debris may prevent flapper movement. Expectations Set, Expectations Met, No Surprises. This process should also be done carefully, otherwise you are likely to damage your equipment.

How To Connect Pool Vacuum To Skimmer

A G2 and similar models like the G3, G4 it is the ring that locks onto the inner extension tube. Make sure the narrow end of the wall climb adjuster points down to the drive tubes, as shown in the picture. How To Vacuum Pool With A Hose Reply With Quote 02-25-2011,07:39 AM #11 XsAllOverIt View Profile View Forum Posts View Articles Join Date Dec 2010 Location Mount Airy, Maryland Posts 561 Re: Help! How To Vacuum A Pool Using Skimmer Originally Posted by PoolGuyNJ Check for the flapper at the skimmer mouth.

There don't seem to be any options or levers on the pump itself that I can see. You can make s seal stretch more easily if it’s warmed with hot water in a sink for a few minutes. When vacuuming, I set it to draw from the pool only. With the pump off open the air bleed by the pressure gauge, & turn the valve leading into the pump to the closed position. How To Vacuum Above Ground Pool

It should turn freely. Reply With Quote 02-16-2011,05:45 PM #6 lacigrl View Profile View Forum Posts View Articles Join Date Feb 2011 Posts 15 Re: Help! Matt Giovanisci If you have mustard algae, read this: http://www.swimuniversity.com/how-to-get-rid-of-mustard-yellow-algae-in-a-pool/ Alec R I noticed chlorine pucks in the skimmer net.. If debris is lodged inside, you can remove the flapper.

Most people hate cleaning a pool… Above Ground Pool Covers Intex Deluxe 18′ Pool Cover The Intex above ground pool cover will fit your 18′ like a glove. Manual Pool Vacuum Walmart If you do not have suction, then you likely still have air in your hose. Yes No Sorry, something has gone wrong.

If your cleaner is getting stuck in a low spot area, try increasing speed or altering the Kreepy direction of travel (see above), or adjusting the hose weight.

Joanna Mendoza Solis I meant mustard type of algee!!! Ive checked the above ground pipes leading too and from the pool, i cant find any leaks or cracks. If you don’t backwash the sand filters the whole filtering process won’t be effective, and make sure you turn off the pumps before you begin. How To Vacuum Pool To Waste To clean the intake hole, just flip the cleaner over underwater and look down into the intake hole.

No suction. I'm at my wits end and have no idea what to try next. Creative Pools & Spas 18,115 views 6:05 How to vacuum your pool - Duration: 3:32. Make sure to keep the other end of the hose in your hand.

However, make sure that large debris is removed from the pool surface in advance. Do they do a better job then just placing pucks in the skimmer basket? If power is being received to the power supply, but the cleaner is not moving, we need to trace the problem towards the cleaner. Next step is to clean your skimmer basket, pump basket, and pool filter.

Unfortunately, I cannot answer that for you as it really is a matter of opinion and budget. Visit our pool cleaner parts department for any spares you need. Make sure the water level is at the proper level, not too high or too low.